Nissan Leaf Owners Manual | 2025
9.15.1.2. Setting speed limit
Once the vehicle reaches desired speed push the <SET> switch (5).
When the vehicle is stopped, the speed will be set at 30 km/h or 20 MPH.
While driving, the speed limit will be set at the current speed.
No other ProPILOT Assist features are available once Speed Limiter mode is active. To use ICC system again push the ProPILOT Assist switch.
When the speed limit is set, the speed limiter indicator and the set speed indicator illuminate on the vehicle information display ([+/- Change Set Speed] message appears on the display).
Changing set speed limit
The vehicle set speed can be adjusted.
To change to a faster cruising speed:
Push up and hold the <RES±> switch (1) to increase speed in 5 km/h (5 MPH) increments.
Push up and quickly release the <RES±> switch (1) to to increase speed by 1 km/h (1 MPH).
Accelerate to new desired speed and push the <SET> switch (5).
To change to a slower cruising speed:
Push down and hold the <RES±> switch (2) to decrease speed in 5 km/h (5 MPH) increments
Push down and quickly release the <RES±> switch (2) to to decrease speed by 1 km/h (1 MPH).
The new set speed limit value will be displayed in the vehicle information display.
When the actual vehicle speed exceeds the set speed, an audible warning will be heard a short time after the set speed is exceeded if driver intervention is not detected.
Speed limiter retains it's on/off state upon EV system restart. When the EV system is started, the Speed limiter will be in the standby mode unless being left in the OFF state in the previous trip and can be set if the driver presses the <SET> switch (5).